Marks on maps and plots
Show saved formulas, conditions and the recording's own events on track maps and telemetry plots, with your own color, line and animation.
Where to find it
- Navigation → Marks
- right-click a track map or telemetry plot → Marks…
- Calculations → Show in… → Map and plot marks
Steps
- 1
Open Marks
Click Marks in the navigation and search. Continuous lists intervals, states and values; Events lists instants, including the recording's own Gearshift and Timing line crossing, tagged Built-in.
- 2
Choose how it is drawn
Click an item. A condition can be shown as Interval, Start points, End points or Start and end points; a formula as Value or as a range statistic (Mean, Minimum, Maximum or RMS).
- 3
Set its look
Pick a Color and an Animation: Static, Pulse, Blink or Flash. Continuous marks can be Solid or Dashed. Set Line width (Size for events) and Opacity (15–100%).
- 4
Choose where it shows
Under Show on, tick the track maps and plots of the current worksheet. In a plot, choose In plot or Own row below. A formula on a map colors the trace by its value.
- 5
Hide or reset
Untick a target to hide the mark there; a row shown nowhere reads Not shown. Restore default appearance drops the item's own look.
Good to know
Marks for one panel
Right-click a map or plot and choose Marks… to list only that panel; × on the Only chip shows everything again.
From a calculation
After saving a formula or state, Show in… → Map and plot marks opens its mark settings. New event or interval… and New formula… at the bottom of Marks start new calculations.
Default appearance
Settings → Mark appearance sets the default line style, line width, opacity and animation for Corner selection and for Formulas and conditions.
Limits
A plot region shows up to 16 formulas or conditions. Interval highlighting is not available for laps from other recordings yet.
Inside the map
Map settings → Marks on a track map ticks marks for that map only.