Marks on maps and plots
Show saved formulas, conditions and the recording's own events on track maps and telemetry plots, with your own color, line and animation.
Dónde encontrarlo
- Navigation → Marks
- right-click a track map or telemetry plot → Marks…
- Calculations → Show in… → Map and plot marks
Pasos
- 1
Open Marks
Click Marks in the navigation and search. Continuous lists intervals, states and values; Events lists instants, including the recording's own Gearshift and Timing line crossing, tagged Built-in.
- 2
Choose how it is drawn
Click an item. A condition can be shown as Interval, Start points, End points or Start and end points; a formula as Value or as a range statistic (Mean, Minimum, Maximum or RMS).
- 3
Set its look
Pick a Color and an Animation: Static, Pulse, Blink or Flash. Continuous marks can be Solid or Dashed. Set Line width (Size for events) and Opacity (15–100%).
- 4
Choose where it shows
Under Show on, tick the track maps and plots of the current worksheet. In a plot, choose In plot or Own row below. A formula on a map colors the trace by its value.
- 5
Hide or reset
Untick a target to hide the mark there; a row shown nowhere reads Not shown. Restore default appearance drops the item's own look.
Conviene saber
Marks for one panel
Right-click a map or plot and choose Marks… to list only that panel; × on the Only chip shows everything again.
From a calculation
After saving a formula or state, Show in… → Map and plot marks opens its mark settings. New event or interval… and New formula… at the bottom of Marks start new calculations.
Default appearance
Settings → Mark appearance sets the default line style, line width, opacity and animation for Corner selection and for Formulas and conditions.
Limits
A plot region shows up to 16 formulas or conditions. Interval highlighting is not available for laps from other recordings yet.
Inside the map
Map settings → Marks on a track map ticks marks for that map only.